The mode of production of wire and cable manufacturing and most of the mechanical and electrical products are completely different. Mechanical and electrical products commonly used component parts assembled into multiple parts and then assembled into a single product, the product to the number of units or the number of measurement. Wire and cable based on the length of the base unit of measure. All wires and cables from the conductor processing, plus the insulation layer by layer in the periphery of the conductor, shielded cabling sheath made of wire and cable products. The product structure is more complex, more superimposed levels.

    Wire and cable products manufacturing process characteristics:
    1. The large continuous length superimposed on a combination of production
    Large length superimposed on a continuous combination mode of production of wire and cable production overall and control, which involve and affect:

    (1) the production process and equipment layout
    Workshop production equipment must be reasonable emissions according to the product requirements of the process, so that the various stages of semi-finished products, sequential flow. Device configuration to consider the production efficiency, the production capacity of the balance, some devices may have to configure two or more units in order to make the production capacity of the production line can be balanced. Thus reasonable the optional combination and production venue layout of the device, must be based on the product and production balance to consider.

    (2) production organization and management
    Production organization and management must be scientific and rational, thorough and accurate, rigorous and meticulous, the operator must be scrupulously executed according to process requirements, any link problems will affect patency of the process, affecting the quality and delivery of products. Especially multi-core cables, the basic unit of length of a line or short, or quality problems, the entire root cable will not long enough, resulting in end-of-life. Conversely, if the length of a cell is too long, must be cut to wastage.